Cleaning and storing the camera

Cleaning the camera

Turn off the camera and remove the battery before cleaning the camera.

Do not use strong solvents such as benzene or alcohol, or a chemically treated cloth.

Exterior:

Wipe gently with a soft cloth. If the camera is very dirty, soak the cloth in mild soapy water and wring well. Wipe the camera with the damp cloth and then dry it with a dry cloth. If you have used the camera at the beach, use a cloth soaked in clean water and well wrung.

Monitor:

Wipe gently with a soft cloth.

Lens:

Blow dust off the lens with a commercially available blower. For the lens, wipe gently with a lens cleaning paper.

Storage

When not using the camera for a prolonged period, remove the battery and card. Store the camera in a cool, dry place that is well ventilated.
Insert the battery periodically and test the camera’s functions.
Remove dust and other foreign matter from the body and rear caps before attaching them.
Attach the body cap to the camera to prevent dust from getting inside when no lens is attached. Be sure to replace the front and rear lens caps before putting the lens away.
Clean the camera after use.
Do not store the camera with insect repellent.
Avoid storing the camera in places where chemicals are treated, in order to protect the camera from corrosion.
Mold may form on the lens surface if the lens is left dirty.
Check each part of the camera before use if it has not been used for a long time. Before taking important pictures, such as during trips overseas, be sure to take a test shot and check that the camera works properly.

Inspecting and Cleaning the Image Sensor

This camera incorporates a dust reduction function to keep dust from getting on the image sensor and to remove any dust or dirt from the image sensor surface with ultrasonic vibrations. The dust reduction function operates when the camera is turned on. The dust reduction function operates at the same time as the pixel mapping, which checks the image sensor and image processing circuitry. Since dust reduction is activated every time the camera’s power is turned on, the camera should be held upright for the dust reduction function to be effective.

Pixel Mapping - Checking the image processing functions

Check the image sensor and image processing functions simultaneously. For best results, wait at least a minute after shooting and playback have ended before performing pixel mapping.

Select [Pixel Mapping].
Select [Yes] and press the OK button.
- The [Busy] bar is displayed when pixel mapping is in progress. When pixel mapping is finished, the menu is restored.

If you accidentally turn the camera off during pixel mapping, start again from Step 1.